THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

As your graph shows your distributor is advancing too early and at maximum nearly 6 degrees too much. Below is a link to a DIY video that explains the function of the springs, spring posts and end stops, and how to adjust/modify the advance curve. As you have the correct specification it would be to...

The reservoir is divided into two compartments.

Yes, you do!

They do join airplanes together with rivets...

Thus with that low voltage, only the old type lead-acid batteries will do?

What is the charging voltage of a Pinz?
Tjerk

Nice LHD Swiss (?) model military green vehicle.

Albert The complaint was that the rear brakes were lacking in stopping power thus the adjustment of link 13 to the proportional load sensor should solve his problem. I doubt if the manual describes a how-to without a rolling brake tester. The link has to be lengthened/shortened till the rear brakes ...

Should we not first look at some basics: The Pinzgauer is equipped with an ATE tandem brake cylinder that contains two pistons. When the brake pedal is depressed, the front piston (nearest to the booster), supplies fluid to the rear wheel cylinders and hydraulically depresses the rear piston to supp...

An engine-mounted compressor and even possibly a radiator-mounted condenser depending on the type of rooftop unit is the way to go.
There are scores of units out there on the market.
I fitted many of these units to vans and buses.
Tjerk

14 x 1,5 mm Radius seat locking wheel nuts can be found at:

https://www.johnbrownwheels.com/product ... nuts-LN11C