THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

Removed because it was no longer pumping fuel. I recall rebuilding the pump over 10 years and it worked fine until recently. Includes new base gasket. $25 shipping included.

Didn't receive your PM, so I sent you a PM.

Hi, replaced this starter motor with gear reduction starter from EI. When attempting to start, would make clicking sound so solenoid may need work.

$50 shipping within continental U.S. included.

Thanks.

Hi, I purchased this new rubber starter mount from EI in December 2022 for $108 with plans to install it when replacing starter motor. Existing mount looked great so didn't install it.

$70 shipping within continental U.S. included.

Thanks.

Harbor Freight special?

Submitted a comment, too.

Might check out Yesterday's Tractors. Here's a link to the vehicle hauling section of the site.

http://www.yesterdaystractors.com/cgi-bin/haulquery.pl

Voted, too. Best of luck!

Yeah, nice looking toys...

I also switched to MT90 some years ago. It seems like it shifts smoother, particularly in cold temps, and it seems like the gear noise wasn't as loud. Probably just wishful thinking, though!

Very nice truck! Is it typical of the Puchs to not have the front and rear lockers as compared to the MB G-Wagens?

You might also consider using a heavier weight gear oil as a temporary measure until fixed properly. I use 90w, but straight 140w is available in some auto parts stores here in the U.S. More viscous, but should still provide the lubricating properties needed for the steering gear.

Likely a seal as TechMogy suggested. Mine has been leaking due to failed seal for a few years. I just continue to fill it up periodically.

Twin Pinzies, what jets did you end up using?

That looks like a nice piece of equipment! Fortunately, I was able to make it useable again with fiberglass, but now need to paint it. Any recommendations, Herculiner, POR-15, etc?

Thanks!