THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

I would say no. Points and condensers are stock

A question has come up about the design of the Pinzgauer. Is it EMP resistant in it's stock configuration?

If not what kind of spares would be required to keep it running?

Thanks Paul.
Nalor Auto near midway airport. They will do mail order. They will also cut the slots/scrapers into the linings.

What is the thickness of the lining for the brake shoes?
I found a place near home to have them relined.

Winter Beater, thanks for the reply. I've found the tools to do the seals. How do you remove the hub with taking the axle off?.

I just pulled my rear tires and drums and found the rear portals leaking. Not a wheel cylinder as I thought. One is worse than the other. Checked the portal fluid levels one good and one low. Question. Can the outer portal seal be replaced without pulling the entire portal axle? I watched Vince's yo...

Refilling one pound propane tanks. Put the tank to be filled in freezer for an hour or so. When filling turn the filling tank over with one pound tank attached and open the valve. It should take less than a minute to get a fill on the one pound tank. 1/2 to 3/4 full. I have refroze the one pound tan...

I first heard of Seafoam when a fellow came to work with me that previously owned an auto supply store (before the national chains). He said that the used car dealers in the Chicagoland area bought it by the case. They would take a car in trade and run it with a ¼ tank of fuel and a can of Seafoam. ...

Thanks Dennis, The starter was rebuilt and now works great. I finally made some time and installed it today. The "bench check" with a pair of jumper cables is NOT the way to check for proper operation. It worked fine on the bench and the starter gear would only go in one direction when I t...

Dennis,Thanks for the reply. I not sure of the proper method of checking the pinion.

I'm having starter problems. Starter will not engage. This what I've tried so far. Replaced the solenoid, checked and double checked the measurment. Soleniod energized 34mm+-1 per the repair manual. Bench tested starter, checked solenoid for proper engagement. Checked the condition of the rubber bac...

I've been using this charger for about 4 years without a problem. It is mounted on the top of the batteries.
http://www.batterystuff.com/battery-cha ... 403SR.html

I have not been able to find any Chevron Delo® Gear Lubricants ESI 85W-140 here in Illinois, or any weight Chevron lube.
Any suggestion on where to find the lube? Is there a suitable substitue out there, other than redline?

I want to do a complete lube change out. I have the Redline GL-4 for the transmission (gearbox).
I'm looking for the lube and the hand pump. I want to change the fluid to something that's readily available in the Midwest. (NAPA Farm & fleet)
Thanks in advance

I just fired up my Pinz last weekend and the solenoid is going out. I was wondering how hard it is to replace?
I haven't even looked at the starter plate.