Clutch alignment tool dimensions (to make your own)

Engine troubles? Try here.
Post Reply
spandit
Posts: 660
Joined: Tue May 18, 2010 5:15 am
Location: East Sussex

Clutch alignment tool dimensions (to make your own)

Post by spandit »

The one I've been lent is just a piece of turned steel, would take someone who can do very basic lathework about 10 minutes to make:

Image
--

Robin

Pinzgauer 710K
MegaJolt ignition
(upgrading to MicroSquirt)
Top
Jim LaGuardia
United States of America
Posts: 1704
Joined: Wed Apr 14, 2004 3:42 pm
Location: San Bernardino Ca
Contact:
Contact Jim LaGuardia

Post by Jim LaGuardia »

use a pilot tool for early 10 spline Mercedes or 70-80 Toyota Land cruiser.
Cheers, Jim LaGuardia
http://smg.photobucket.com/albums/v510/Goatwerks/
"Arch Magus of Machines."
Top
spandit
Posts: 660
Joined: Tue May 18, 2010 5:15 am
Location: East Sussex

Post by spandit »

It's not the most difficult tool to make/obtain - just thought I'd post this for interest' sake.
--

Robin

Pinzgauer 710K
MegaJolt ignition
(upgrading to MicroSquirt)
Top
Post Reply

Return to “Engine”