I was in the process of changing my u-joints and I ordered them from sav and received them and to my surprise they do not fit too small?!?!?! I contacted them and they said that there is only one size and it must be my pinz has been modified?!?!? So now I'm in a bit of a pickle I can't find right size and local auto parts store has nothing similar.
Any ideas?
I have a small problem
- cruzoropeza
- Posts: 126
- Joined: Thu Nov 25, 2010 12:15 am
- Location: Los Angeles, CA
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact:
Re: I have a small problem
Take the old U joint and the driveshaft to DRIVELINE SERVICE. They are a big company and may be able to I.D. your joints if they are modified.
Quick question, did you buy the factory joints(with grease fittings) or the non serviceable aftermarket joints(without grease fittings)?
Quick question, did you buy the factory joints(with grease fittings) or the non serviceable aftermarket joints(without grease fittings)?
- cruzoropeza
- Posts: 126
- Joined: Thu Nov 25, 2010 12:15 am
- Location: Los Angeles, CA
Re: I have a small problem
I went with aftermarket..
-
- Posts: 436
- Joined: Wed Apr 14, 2004 2:53 pm
- Location: Vallejo, CA
- Contact:
Re: I have a small problem
Our drive shaft shop refuses to install the aftermarket joints. We have tried on 3 occasions over the years and always had less than stellar results. I have not had a problem with the factory joints. I believe the factory joints are GBH?
Cheers,
Scott
Cheers,
Scott
Expedition Imports Corporation
Vallejo, California
www.expedition-imports.com
"You didn't buy a Chevy..." "Hows that Amazon tech support working out...."
Vallejo, California
www.expedition-imports.com
"You didn't buy a Chevy..." "Hows that Amazon tech support working out...."