Transmission Input shaft

rospaw · Post by **rospaw** » Thu Jun 16, 2011 10:54 pm

Trying to get my parts ordered. I have to change out the input shaft on the transmission due to a grove that has warn in it. Noticed it when i pulled the clutch. When changing this shaft what other parts (gaskets, seals ect) do i need? Thank ahead...... Shawn

edzz · Post by **edzz** » Thu Jun 16, 2011 11:06 pm

you might be able to use a repair sleeve if proper size is avalible.

http://www.vsm.skf.com/en-US/HeavyDuty/ ... leeve.aspx

Ed

pinzdriver · Post by **pinzdriver** » Fri Jun 17, 2011 11:04 pm

You will have to split the trany case to replace the input shaft and take it from me you dont want to open up that can of worms.

cruzoropeza · Post by **cruzoropeza** » Sat Jun 18, 2011 12:37 am

been there take it a step at a time! your lucky you know where the problem is, one of my transfer gave out in my pinz and i could pin point where the problem was i ended up taking it all apart to find the problem!

rospaw · Post by **rospaw** » Sat Jun 18, 2011 2:12 am

cruzoropeza wrote:been there take it a step at a time! your lucky you know where the problem is, one of my transfer gave out in my pinz and i could pin point where the problem was i ended up taking it all apart to find the problem!

Man that looks like a project from .....!

I don't mind spilting the case (been in a tranny or two) but sure would like to know gaskets, seals ect that i will need and a few i might need. When doing it i would like to tear down and build it back in the same eve. Keeps thing fresh on where they go-went-might fit

edzz · Post by **edzz** » Mon Jun 20, 2011 5:50 pm

rospaw I sent you a PM check your messages

THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

Transmission Input shaft

Transmission Input shaft

Re: Transmission Input shaft

Re: Transmission Input shaft

Re: Transmission Input shaft

Re: Transmission Input shaft

Re: Transmission Input shaft