Dash Locker Switch
Posted: Sun Jun 19, 2016 3:56 pm
I am currently in the process of replacing the center lower dash piece on my C303. It contains the front and rear locker switches and 4x4 engagement button.
It is being replaced with a switch panel. I would like to convert the current manual vacuum locker switches over to electric solenoids so the new switches can operate them.
My question is should the solenoid be normally opened or closed?
Any advice would be great, thank you.
It is being replaced with a switch panel. I would like to convert the current manual vacuum locker switches over to electric solenoids so the new switches can operate them.
My question is should the solenoid be normally opened or closed?
Any advice would be great, thank you.