THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

WTB Manuals for 1986 Unimog SEE. Not PDF . The old time paper ones. Parts, Repairs / Trouble Shooting and any others.
Also need new starter and solenoid for same. ASAP.
Thanks in Advance.
Mact

BenzWorld.org may be a better place but I would also check with Scott over at EI for manuals
As for starter - there's one posted on the UnimogExchange
Ad #44
Guy is asking $300 and it's NOS
No affiliation
http://unimog.net/exchange/

That's a deal on that 352 motor too, if it really only has 190 hours!

For what kind of UNIMOG did you want this manual ? I have many manuals (NOS Parts) from Unimog.

It's a (406) 419/U900/MB4/94! The manuals would likely need to be US specific. I think they were only outfitted in that particular way for the US market by Case and then for US military use, when they called them "SEE" for Small Emplacement Excavator and High Mobility Material Handler "HMMH". I believe Freightliner handled them later in the 80's and were modeled the FLU-419's.

Lots of them have turned up on the market because the US mil. has let a bunch (or all?) of them go. Several have popped up at Gov. Planet in Yermo Ca. for auction. I saw two parked near the gate last time I drove through there. (about to go by there again for Mogfest)

The mil. ones are camo and some green or tan, while the Case models are bright orange and outfitted differently.

Thanks for all the information.
I have found the parts. Cross the MB # .
Still would like good Manuals for the SEE 416.
I think I have been spoiled by the Pinzaguer ones. They are very complete and easy to get understand.
Unimog ones just not as good.
Hopefully some has some they need to part with.
Thanks Again

I've been looking at these. I see one for 20k in texas. What do they normally go for?

It's a big risk. The maintenance issues can be massive. I'd go for as like-new as possible. Prices are all over the place because condition here matters more than it might elsewhere. I've seen $7K to $25K.