Selling my custom Brush Guard. This is a "lean forward" style Brush Guard and NOT fitted for a Winch.
I replaced this with a bumper/guard fitted for a winch and thus no need for it at this point.
It's fab'd with 1.66" steel tubing rather than the more common 1.75", thus looks far less bulky.
It has served me well on the trail adverting body dings and dents. It adds additional crash protection
over the wimpy stock bumperettes. Mounts via the four M12 front bolts with four steel spacers. I
have all the hardware (SS Eyelets not inc.). I had it blasted and re-powder coated Black/40% gloss
a few years ago. Apart from a scuff here and there -- doing it's job -- the finish is in decent shape.
Easy to mount LED flood and beam and other accessories. I used Warn clamps which have plastic
inserts so no mounting rashes.
PIX's show mounted on 710 with all the accessories, mounted on the 712 bare no jewelry.
Asking $500. If you think that's expensive welcome to custom fab for a Pinz'y -- unless you fab stuff
yourself Shipping would be expensive, you should expect +$200.
If your in the Bay Area we could work out a meet. Or there's Mogfest coming in Calico I could haul it.
For Sale: Pinz Custom Brush Guard
For Sale: Pinz Custom Brush Guard
Puller: 71' 710K 2.7L EFI aka Mozo
Follower: Sankey MK 3, 3/4 Tonne
Rescue Pinz: 73' 712MK
Driver: Ron // KO0Q
Follower: Sankey MK 3, 3/4 Tonne
Rescue Pinz: 73' 712MK
Driver: Ron // KO0Q
Re: For Sale: Pinz Custom Brush Guard
A potential buyer PM'd me with a question on more details on how this Brush Guard mounts.
I have taken a few more shots, mounted on the removed bumperettes. In short this is mounts
at 6 points, 4 M12 bolts to the front and 1 each 1/2" bolt to each bumperette -- adding more
structural strength with a tube and bumperette.
Top down view with bumpetette/guard as it would attach to the front throat: Side view of bumperette/guard showing 1" steel spacers, bolt through guard, spacer, then bumperette: Bumperette attach to front tubing via 1/2" bolt: Hope this makes it a bit clearer.
P.S. New winch bumper back from Powder coating and mounted, waiting for the winch.
I have taken a few more shots, mounted on the removed bumperettes. In short this is mounts
at 6 points, 4 M12 bolts to the front and 1 each 1/2" bolt to each bumperette -- adding more
structural strength with a tube and bumperette.
Top down view with bumpetette/guard as it would attach to the front throat: Side view of bumperette/guard showing 1" steel spacers, bolt through guard, spacer, then bumperette: Bumperette attach to front tubing via 1/2" bolt: Hope this makes it a bit clearer.
P.S. New winch bumper back from Powder coating and mounted, waiting for the winch.
Puller: 71' 710K 2.7L EFI aka Mozo
Follower: Sankey MK 3, 3/4 Tonne
Rescue Pinz: 73' 712MK
Driver: Ron // KO0Q
Follower: Sankey MK 3, 3/4 Tonne
Rescue Pinz: 73' 712MK
Driver: Ron // KO0Q