Page 2 of 2
Re: How do i LOWER the k/ph on a sync tool / carbs
Posted: Fri May 31, 2013 6:17 pm
by audiocontr
How about a video?
http://www.youtube.com/watch?v=qkDN8g1uUhY
The rear carb started dripping fuel this time. Looks like i need to adjust the float valve there. Would that do it?
Re: How do i LOWER the k/ph on a sync tool / carbs
Posted: Fri May 31, 2013 7:07 pm
by Jim LaGuardia
Before continuing, replace the leaking float valve. Pump rods are 80mm when set correctly.
Re: How do i LOWER the k/ph on a sync tool / carbs
Posted: Fri May 31, 2013 8:25 pm
by audiocontr
Id love to Jim, but i cant...
Tried 3 different valves, and all 3 sizes of the shims combined and it still drips, but only when the engine is running. It stops dripping immediately when i shut it off. Any ideas?
Re: How do i LOWER the k/ph on a sync tool / carbs
Posted: Fri May 31, 2013 9:14 pm
by audiocontr
float screws are solid by the way.