Page 1 of 1
Help with shifter removal
Posted: Wed Jun 04, 2025 8:11 pm
by whitesik
I need help. I am helping a friend with his 710m and we need to remove the shifter. We can not get the "shifter shaft" removed. This is Group: 02-30-03 in the diagram. The roll pin, Group 02-30-02, has been removed. We really don't see a plastic bushing, Group: 02-30-01. We have tried to punch this out, mainly right to left without success. We have used s significant amount of PB blaster and heat. What are we doing wrongly. Any tricks or advice? Thanks.
Re: Help with shifter removal
Posted: Thu Jun 12, 2025 6:35 am
by whitesik
nobody?
Re: Help with shifter removal
Posted: Thu Jun 12, 2025 4:27 pm
by rmel
Wish I could help Keith....but of all the things I have torn apart
the shifter was not one of them
Re: Help with shifter removal
Posted: Thu Jun 12, 2025 7:06 pm
by whitesik
Thanks! It looks straight forward but that pin will not budge. One would think the plastic shim means it is a little loose. I thought maybe it was tapered but the drawing does not imply that.