What's jake up to?
Posted: Mon Sep 17, 2007 8:45 pm
Jake what's the word on a 3.3L for the pinz? 
The 3.3 is ready for assembly after the crank is final cut. The cylinders and pistons are done and the heads have had their port work completed and valve upgrades done.
I have been so tied up with the EFI development that not much else has been going on with Pinz development work at all.
I have a Pinz engine on the R&D dyno today, it'll be there for the next two weeks trying to work out the issues with the low speed and idle choppiness.
The 3.3 should be done sometime in 2008