How do i LOWER the k/ph on a sync tool / carbs

audiocontr · Post by **audiocontr** » Fri May 31, 2013 6:17 pm

How about a video?

http://www.youtube.com/watch?v=qkDN8g1uUhY
The rear carb started dripping fuel this time. Looks like i need to adjust the float valve there. Would that do it?

Jim LaGuardia · Post by **Jim LaGuardia** » Fri May 31, 2013 7:07 pm

Before continuing, replace the leaking float valve. Pump rods are 80mm when set correctly.

audiocontr · Post by **audiocontr** » Fri May 31, 2013 8:25 pm

Id love to Jim, but i cant...

Tried 3 different valves, and all 3 sizes of the shims combined and it still drips, but only when the engine is running. It stops dripping immediately when i shut it off. Any ideas?

audiocontr · Post by **audiocontr** » Fri May 31, 2013 9:14 pm

float screws are solid by the way.

THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

How do i LOWER the k/ph on a sync tool / carbs

Re: How do i LOWER the k/ph on a sync tool / carbs

Re: How do i LOWER the k/ph on a sync tool / carbs

Re: How do i LOWER the k/ph on a sync tool / carbs

Re: How do i LOWER the k/ph on a sync tool / carbs